Yunca Monte (CA Sub 0.7) with base details

Back to burner list
Appliance name Yunca Monte (CA Sub 0.7) with base
Situation Freestanding
Fuel type Dry Wood
Emission 54 mg/MJ
Emission factor 0.7 g/kg
Efficiency 66 %
Water heater None
Approval number 122761

Conditions

  1. A certificate shall be submitted to the Canterbury Regional Council within 12 months of approval, and annually thereafter, signed by a competent person, verifying that the model being sold as the Monte with base (CA Sub 0.7) freestanding woodburner (without wetback), is the same as that which was tested and described in Test Report ARS12/2526 & ARS12/2531.
  2. This approval applies only to the specific model described in the testing reports, documents and drawings accompanying the application for authorisation.
  3. A permanent label shall be attached to each appliance in a position that is readily visible after installation. The labels shall contain the following information:

    1. the manufacturer of the appliance (Terry Young Limited);
    1. the unique model name (Monte with base (CA Sub 0.7);
    1. the unique serial number of the appliance;
    1. the number of the test report in which the appliance is described (ARS12/2526 & ARS12/2531);
    1. the authorisation number (122761);
    1. the approved fuel for use in the heater (soft wood);
    1. the measured (average) particulate emission rate in grams per kilogram (0.7 g/kg);
    1. the measured emission rate per unit of useful heat output (54 mg/MJ);
    1. the percentage measure of thermal efficiency (66%);
    1. the range of heat outputs tested (9.7 kW – 13.1 kW);
    1. the statement “Performance may vary from test values depending on the actual operating conditions; and
    1. space to allow the installer to place the date of installation.
  4. There shall be no water heating device fitted to the appliance.
  5. There shall be no circulation fan fitted to the appliance.
  6. The appliance shall be operated at all times in accordance with the “Installation and Operating Instructions” supplied with each appliance.
  7. The only fuel to be used in this appliance shall be wood that meets the following criteria:
    1. less than 25% moisture (dry weight);
    1. has not been treated with preservatives or impregnated with chemicals or glue;
    1. is not chipboard, particle board or laminated board; and
    1. is not painted, stained or oiled.